Starlink's worry-free module: plug and play, integrated SPX plug (dish antenna and router) and female RJ45 adapter (T568B) in one cable (pair). There is no need to cut and crimp the original Starlink cable or use an additional adapter with increased contact resistance.
Indoor and outdoor user-friendly: equipped with a waterproof kit for connecting a conventional Ethernet cable to a female RJ45 adapter. After connection, both the female and male terminals are waterproof. Prevent network components from getting wet and dirty to ensure connection quality.
Increase the modification potential of Starlink: The kit includes a disc-shaped and router-side SPX plug to the female RJ45 adapter, which provides modification options for your Starlink equipment, allowing you to choose to use a third-party PoE injector and router or use the original Gen 2 Starlink router to power your tableware in various usage scenarios.
High-quality materials: The cable is made of 24AWG single-core bare copper and shielded with a high-quality anti-aging layer to ensure transmission speeds of up to 1200Mbps and provide stable power for your Starlink equipment.
Stable and uninterrupted connection: This cable is designed to meet the highest standards and guarantees a stable and uninterrupted connection, allowing you to enjoy seamless Internet access.
Product parameters
Product name: Starlink SPX male to RJ45 adapter
Material: Rubber + copper
Specification: RJ45-1 RJ-2
Transmission rate: 1200mbps (Kpbs)
Operation instructions
Direct connection use
Packing list
Starlink SPX male to RJ45 adapter*2
Precautions
[Important installation tips]: The contact resistance is too high, which will cause the circuit voltage drop and cause Starlink to operate abnormally. It is recommended that you use a single Cat6 or better Ethernet cable without coupler/extender to ensure that the length does not exceed 175 feet when used with genuine Gen 2 routers. For self-made crimped Ethernet cables, please ensure a strong connection between the high-quality RJ45 end and the cable. Make sure that the waterproof socket is installed correctly and do not twist or tear the end of the cable. [RVers special note]: In scenarios where a third-party PoE injector and Ethernet cable coupler/extender are required, the output power of the third-party PoE injector is unstable and the contact resistance is too large, which may cause the voltage to drop. Please choose Cat6A or better. 23AWG or higher and high-quality RJ45 ends can achieve a reliable connection. Please make sure that the length of the conventional Ethernet cable between the dish antenna and the PoE device should not exceed 75 feet.
